ALL ANALOG MODELS:
"TimerStat PRO" Controller

back to Analog/Digital

New TimerStat Pro Analog Control

 

 

The NEW Analog "C" Series Heat Siphon's began shipping in August 2018 with our new TimerStat Pro Controller that adds a sophisticated status LED light while keeping our economical original "Set It & Forget It!" single knob design. The LED can display red green & orange to let you know the status of your Heat Siphon at a glance, including - POWER, NO FLOW, HEATING, HI/LOW Pressure Error, Reset Breaker Error & Call Factory for Service.

And if you would like to complicate your life a little and switch to a digital Heat Siphon model, say you want to go wireless or control some valves . . .

Easily Convert to Digital Later:

The TimerStat Pro mounts in the same door as the digital Player Models. This allows a direct replacement upgrade to Digital without any wiring or harness changes other than a simple jumper.

Just remove the door, unscrew the plug and replace it with a digital Player door assembly.

If your so inclined, just call us & order a Player Conversion Kit.

Heat Siphon
Analog Models

One Knob Classic:
Set It & Forget It!!

 

Since 1983, we made analog models for people who like to keep it SIMPLE.

Easy to troubleshoot, simple series wired switches and one knob.

1983 Heat Siphon / 2010 Timerstat

Over the years the knob has changed from thermoset plastic (1983) on our electro-mechanical thermostat to a stainless steel on the 2010 TimerStat model . . . to the current modern rubber coated plastic knob you see to the left.

BUT the concept has endured -

Turn the knob up and let it run until the pool is at your preferred temperature -

THEN JUST LEAVE IT ALONE.

As long as the knob doesn't move, the pool temperature won't either.

Status Lights Added

In 2018, we added a status LED -

WHEN IT IS SOLID GREEN - the WATER'S WARM - JUMP IN!!

Simple. Dependable. . . Heat Siphon.

"We Perform to Keep You Warm!!"