Heat Siphon® Swimming Pool Heat Pumps "No Tank, No Flames!!" ANSWER BOOK

Heat Siphon® is Very Simple to Install REQUIREMENTS: • MINIMUM OF 25 GPM POOL PUMP WATER FLOW (80 GPM MAX) • DEDICATED 220 VOLT AC CIRCUIT BREAKER (Domestic Models) No gas lines, tanks, heat sinks or wind breaks Just PVC pipe and electrical wire It should take only a few hours.   Heat Siphon® can be installed by any factory authorized pool dealer or pool service contractor. Depending on local building code requirements, the installing dealer may also be able to run electrical wiring to the unit or may subcontract a licensed electrician. General Installation Info: LOCATION - Heat Siphon® needs fresh air so it must be outdoor in the open - NO PUMP ROOMS OR SHEDS (for indoor installations call factory) and it should be downstream of the pump and filter and upstream of any chlorinators. PLUMBING - Heat Siphon® is plumbed right into your pool or spa filter circulating system just like a length of PVC pipe. AND NO COPPER HEAT SINK PIPES are required. Just plumb standard 1.5" or 2" schedule 40 PVC pipe directly into Heat Siphon®'s heat exchanger by simple slip glue joints. WIRING - 220 volt ac electric power from a dedicated circuit breaker is the only "fuel" required to power the unit. IT'S THAT SIMPLE