The following is GUIDANCE FOR HEAT SIPHON® OWNERS with some technical background who have a problem with their Heat Siphon®.

If our guidance here doesn’t solve the problem CALL YOUR INSTALLER and refer him to the Installer Section of your manual. He will contact the factory service center for additional service if required.

ALERT: False "No Pod" Error

On digital Player equipped Heat Siphons a power surge can cause a "false" No Pod error.

A "true" NO POD error occurs if you have a hardwired Pod accessory hooked up to the Player AND the Player can't detect the Pod devices contactor coil. If you have no Pod and this error occurs simply cycle power by turning the breaker off then back on and it should clear this error.

Basic POOL OWNER Trouble Shooting

When you apply power to your Heat Siphon® through the disconnect and circuit breaker, usually one of three things will happen:

Click on one for Detailed Troubleshooting Steps

1. IT DOES NOTHING
2. IT TRIES TO START THEN SHUTS OFF
3. IT STARTS & RUNS but doesn’t heat
4. IT LEAKS WATER

In any case you are probably reading this because your pool is not heating to the desired temperature, so follow the appropriate steps below BEFORE CALLING YOUR DEALER:

Click to DOWNLOAD PDF Files

1. Analog Heat Siphon Dealer Manual
2. Analog Heat Siphon Installers Manual
3. AnswerBook Excerpt - General Troubleshooting
4. AnswerBook Excerpt - Digital Error Codes